Recommended: 1 year of inspections or assisting on 10 different pre-engineered installations
Credits: 16 EECs
** Please bring the required NFPA standards **
Standards may be purchased through NFPA (www.nfpa.org).
Required: NFPA 17, NFPA 17A, NFPA 96
PDF: If you prefer to register by fax or mail, download the registration form.
PLEASE NOTE: This class requires a minimum number of technicians to take place. Please do not book your flights/accommodations until 30 days before the class and after you have received confirmation that the class met the minimum requirement.
Day 1 will cover:
UL300 and Upgrading pre-UL300 Wet Systems
Duct Design, Oversized Exhaust Ducts, Transition Ducts, Common Ducts, Electrostatic Precipitators, PCUs, Access Panels, Fire Dampers
Plenum Design, Single Bank Filters, V-Bank Filters, Upper and Lower Plenum, Baffle and Mesh Filters
Existing Hoods and Fire Suppression, Type I and Type II Hoods, Water Wash Hoods
Appliance Design, Standard Coverage, Specific Coverage, Modularizing Large Appliances
Appliance Design, Continued
Day 2 will cover:
General Piping Limitations, Equivalent Pipe Length, Manifold Piping, Support Piping, Conduit, Grease Seals
Overlapping and Total Flood Protection
Accessories: Detection, Remote Pull, Fuel Shutdown, Reset, Relays, Cartridges
Industrial Dry Chemical Suppression, Booth Types, Hazard Types, Gas Stations
General Piping Limitations, Balanced Piping, Detection, Main and Reserve, Powder Coating, Explosive Hazards